Click PLC Shift Register Instruction

A lot of times when programming a PLC you need to track what has previously happened. Shift registers allow you to do just that. The Click PLC has a shift register in the instruction set. We will discuss the shift register and look at an example. The shift register instruction will move a range of consecutive bits. This movement is controlled by the clock input bit which will trigger with each transition from off to on. The bits continually shift with the clock pulse until the end bit number. When the bit shifts past the last bit number then the bit information is lost. The data input will put a ‘1’ or a ‘0’ in the first bit of the shift register. (Note: We can also put bits on anywhere within the shift register.) Reset input will clear the shift register by putting a ‘0’ in each of the bits in the range. More information can be obtained at our website. This includes all of the links mentioned in this video. https://accautomation.ca/click-plc-shift-register-instruction 00:00 Click PLC Shift Register Instruction 00:33 Click Shift Register Instruction Parts 02:08 Monitoring the Shift Register Bits 03:19 Adding Additional Inputs to a Shift Register 05:31 Click Shift Register Timing Chart 06:15 Shit Register Instruction Sample Program Previously we discussed: Click PLC System Hardware. http://accautomation.ca/click-plc-system-hardware/ Click PLC Installing the Software http://accautomation.ca/click-plc-installing-the-software/ Click PLC Establish Communication http://accautomation.ca/click-plc-establish-communication/ Click PLC Numbering System and Addressing http://accautomation.ca/click-plc-numbering-system-and-addressing Click PLC Timers and Counters http://accautomation.ca/click-plc-timers-and-counters Click PLC Compare and Math Instructions http://accautomation.ca/click-plc-compare-and-math-instructions Click PLC Program Control Instructions http://accautomation.ca/click-plc-program-control-instructions Download the Click Programming software at the following address: http://support.automationdirect.com/products/clickplcs.html There are several reasons why we are using the Click PLC. Here are just a few. - Investment is low for the hardware and the software is free - Standalone PLC with built in I/O - Communication ability - Ethernet Port, RS232, RS485 - support for protocols such as Modbus RTU, Modbus TCP, etc. - Ability to expand the system with a variety of modules including RTD and Thermocouple inputs directly. https://www.accautomation.ca